I've spent the last couple weeks putting about 2 hours a day, every other day sanding the entire exterior of the kayak. After the final fill coat of epoxy on the deck fiberglass, I decided that I needed to get this done now instead of later. A lot of sanding. Weather was good so took the kayak outside and got it done. A lot of drips and runs, especially on the bow and stern. Got the kayak nice and smooth so when it's time to varnish, minimum prep will be required.
Next, on to the coaming installation.
Here's the lower coaming on the right side of the cockpit. Only have enough clamps to do one side at a time. I did the same the next day on the left side. While doing this, I fiberglassed the upper coaming getting it ready for installation.
I then installed the upper coaming.
And here's what that looks like.
No comments:
Post a Comment